Fitting subsequent Modular sections.
To do this you have two options:
1.
Fit extra extension sections by sliding the extension over the end of the
pole hose (disconnect from hose reel or tap first). Slide extension on to
the stepped base of the extension section above and clamp in the fully
inserted position.
2.
Recommended method is to remove the pole from the gooseneck before
starting work and run the pole hose externally down the pole.
To achieve method 2 follow these steps:
A.
Pull out the gooseneck assembly from the pole and disconnect the pole
hose and pull out from the pole.
B.
Re
-
fit the gooseneck assembly on to the top of the pole.
C.
Disconnect the Brush Jet Hose T connector from the Gooseneck hose.
D.
Connect the pole hose directly to the Brush Jet Hose T connector.
E.
EZ
-
Wrap strap the pole hose to the outside of the gooseneck.
F.
When extending the pole allow the pole hose to gently wind around the
pole.
G.
Extra extension sections can now be easily fitted and removed as required
during use. Once extensions are finished with the pole hose can be run
back down the inside of the pole again.
H.
If using with more than 3 extensions you will need to purchase a longer
hose pack for the pole.
