Gardeo GSEBR650FULL, Инструкция по эксплуатации

Страница: 32 / 39

during operation. Protect yourself from falling oil drops with suitable protective clothing.
To operate the Westfalia Electric Pole Saw push forward the Safety switch (10) and then pull
the switch (11).
The Westfalia Electric Pole Saw is equipped with a low-kickbach chain and it was also done
everything from an engineering point of view to keep kickback low. Nevertheless, some
kickback can not be avoided when cutting with the upper tip of the blade. Be prepared for
some kickback when using this area of the blade or hitting another branch with this area.
Always hold the unit firmly in both hands.
Thin branches can be cut off with one single cut. To prevent the branch from slivering and
buckling the branch should be cut off in several pieces.
When cutting off lager branches, you should first cut into the branch form below. First cut into
the branch from below outside the place where you intend to cut off the branch.
The cut should go from one third to halfway through the branch. This prevents the branch
from buckling when you cut into the branch from the top
outside the first cut. Last, cut off the
stump with one clean cut. You might want to seal the cut with a suitable compound.
Storage
If you do not intent to use the Westfalia Electric Pole Saw for some time, e.g.
over the winter, the bio-degradable chainsaw oil must be drained from the oil tank and the oil
ducts, because it will gum. Pour remaining oil out of the oil tank and store it in a dark, cool
place. Pour a spoonful of mineral oil into the oil tank. Spray penetrating lubricant on the chain
and let the saw run for a few moments to spread the mineral oil through the oil pump and the
oil ducts.
When using the pole saw again liberally apply chainsaw oil. Hang the Pole Saw upright, with
the saw end on top, by its build-in hook.
Repairs and Changing the Carbon Brushes
Repairs beyond those described above, should only be undertaken by trained personal.
Should a malfunction occur do not use the unit any further and do not attempt to repair it
yourself. Contact the Westfalia Customer Support or have the unit repaired by a professional.
The included carbon brushes are intended as spare parts for installation by a professional.