GARDEO PRO GPDCBT52, Оригинальное руководство пользователя

Страница: 92 / 109

10
For nearly all cutting, it is good to tilt the line head
so that contact is made on the part of the line circle
where the line is moving AWAY from you and the
debris shield. (See appropriate) This results in the
debris being thrown AWAY from you.
TRIMMING:
This is feeding the trimmer carefully into the
material you wish to cut. Tilt the head slowly to
direct debris away from you. If cutting up to a
barrier such as fence, wall or tree, approach from
an angle where any debris ricocheting off the
barrier will fly away from you, Move the line head
slowly until the grass is cut right up the barrier, but
do not jam (overfeed) the line into the barrier. If
trimming up to a wire mesh or chain linked fence be
careful to feed only up to wire. If you go to far the line will snap off
around the wire. Trimming can be done to cut through weed
stems one at a time. Place the trimmer line head near the bottom
of the weed-never high up which could cause the weed to chatter
and catch the line. Rather than cut the weed right through, just
use the very end of the line to wear through the stem slowly.
WARNING
△
,!
DANGER
Do not to use a steel blade for edging or scalping.
SCALPING AND ENGING:
Both of these are done with the line head tilted at a steep angle
Scalping is removing top growth leaving the earth bear.
Edging is trimming the grass back where it has spread
over a sidewalk or drive way. During both edging and
scalping, hold the unit a steep angle and in a position
where the debris, and any dislodging dirt and stones,
will not come back towards you even if it ricochets off
the hard surface. Although the picture shows how to edge and scalp
every operator must find for himself the angles which suits his body
size and cutting situation.
WARNING
△
,!
DANGER
Use only quality nylon monofilament line of the
diameter 2.5mm, Never use wire or
wire-reinforced line in place of nylon trimmer line.
Load your nylon line cutting head only with nylon
trimmer line of the proper diameter.
WARNING
△
,!
DANGER
Use extreme caution when operating over bare
spots and gravel, because the line can throw
small rock particles at high speeds. Debris
shields on the unit cannot stop objects which
bounce or ricochet off hard surfaces.