S
U
A
1800 909 909
www.globalpowerbrands.com email: [email protected]
AFTER SALES SUPPORT
43669
13
Fitting the collection bag
WARNING
Never operate the vacuum without collection bag attached.
Serious personal injury could be the result if the blower vac is used without the
bag fitted.
IMPORTANT
Before using this appliance, ensure the vacuum bag tube is in
position and the zip is done up.
Note.
Always make sure the bag zipper is closed when the unit is in use.
For use as a vacuum, the collection bag (18) must be fitted.
The collection back fits on to the outlet of the blower vac
housing, where the blow tubes are fitted when used in
blowing operation. If the blow tubes are fitted, these need to
be removed. Remove the two retaining screws, rotate the tube
as far as possible and then pull the tube off the blower.
1. Align the collection bag tube to the outlet of the vac. Push the
collection bag tube onto the outlet housing as far as possible.
2. Rotate the tube until the retaining holes
align. Check the orientation of the tube
to ensure the tube is pointing downward
and NOT upward. (Refer pic). If upward
rotate the tube in the reverse direction
to assembly, and remove from vac. Turn
the tube 180° and refit. Again, check the
orientation of the tube with the pic.
3. Fit the two retaining screws to hold the
collection tube in place.
Note.
If your collection bag becomes worn replacement
bags are available for purchase. Please refer to page 23 for
further detail.
Instructions
5