S
U
A
1800 909 909
www.globalpowerbrands.com email: [email protected]
AFTER SALES SUPPORT
43669
11
Assembly
Preparation of the blower vac prior to use
The petrol blower vac requires some assembly prior to use. This includes joining
of the vac tubes, joining of the blower tubes, and depending if the tool is to be
used for blowing or vac, fitting of the tube assembly to the housing and fitting
the collection bag assembly to the housing. A medium size phillips screw driver is
required to make the above assemblies.
Setting up for use as a blower.
IMPORTANT.
Blower tube installation affects both blower balance and
performance. Both tube and nozzle must be screwed together.
WARNING.
Danger from rotating impeller!
Stop the engine before installing or removing the blower tubes. Never perform
any maintenance or assembly procedures on this machine while the engine is
running.
Attaching the blower tube
1. Place the blower upright on the ground
or on a sturdy work surface.
2. Push the blower tube nozzle tube (5) over
the lower blow tube (4), lining up the
locking pins.
3. Rotate the blow tube nozzle clockwise on
the lower blow tube locking it into place.
4. Lock the tubes together using the 2
screws provided.
5. Align and then push the assembled
blower tube assembly over the discharge
port on the blower outlet and rotate until
locks in place and the screw hole can
be seen.
Getting Started
4
