Gardenline GLH 692, Руководство пользователя

Страница: 15 / 23

Operation
15
Preparations
1. Check the hedge: It must not be wet. Remove any foreign objects, such as wires or
planting sticks.
2. Check the hedge trimmer to ensure all screw fittings are securely seated and the
blade with double cutter 4 is sufficiently sharp.
3. Fully extend the extension cord in loops so that you can pull it towards you from
behind when working.
4. The cable strain relief 8 prevents the extension cord from being accidentally
disconnected when cutting: Form a loop with the last 30 cm of the extension cord.
5. Guide the loop through the cable feed-through 9 and over the hook for the
cable strain relief (see
Fig. B
).
6. Slowly pull the loop against the cable strain relief to tighten it. If the loop is not
taut, the cord may become loose and slip out when working.
7. Insert the mains plug 7 in the extension cord connector.
8. Insert the mains plug of the extension cord in a properly installed socket.
Operation
Switching on and off
WARNING!
Risk of injury!
The double cutter will continue to run for a short period of time after
switching the hedge trimmer off!
− Hold the hedge trimmer securely until the double cutter
comes to a standstill.
The hedge trimmer is fitted with a two-hand safety circuit. It works only when one
hand presses the switch on the guide handle 2 and the other hand presses the
switch on the grip
1
.
1. Hold the hedge trimmer by the guide handle. If you are right-handed, use your
left hand. If you are left-handed, use your right hand.
2. On the protective cap 6 , gently press on both sides of the locking mechanism for
the protective cap 5 , and pull the protective cap off forwards.
3. Put the protective cap nearby.
4. Ensure that the blade with double cutter
4
is not touching anything so that the
double cutter can be started safely.