Gardenline GCGS 18-S, Руководство по эксплуатации

Страница: 11 / 14

GB
9
When inserting the hedge trimming blade, note the
position of the eccentric pin (Figure 7 / Item 1).
Take the hedge trimming blade and slide the
eccentric mount (Figure 8 / Item 1) into position so
that the eccentric pin fits exactly in the eccentric
mount when assembled. To secure the hedge cutter
blade for cutting, slide it underneath the holder
(Figure 7 / Item 2) and fasten it in place with the
screws (Figure 10 / Item 1).
When inserting the grass cutting blade, again note
the position of the eccentric pin (Figure 7 / Item 1).
With the grass cutting blade you can slide the
eccentric mount (Figure 9 / Item 1) to the left or right
in order to find the position where the eccentric pin
(figure 7/item 1) fits in the eccentric mount (figure
9/item 1). Re-fasten the grass cutting blade with the
screws.
9. Maintenance and cleaning
To achieve good results you should keep the blades
sharp at all times. In particular we recommend that
you immediately level off any jags or ridges caused
by stones or the like. The tool should be thoroughly
cleaned both before and after use. A few drops of oil
(e.g. sewing machine oil) will improve the cutting
performance of the blades, but never apply any
grease to the blades. To ensure constant exact
cutting it is also important to remove grass remnants
and dirt from between the upper and lower blade.
Important!
Never clean the tool under running water - and
particularly never with high pressure - because
of the potential danger to persons and property.
Keep your cordless grass cutter and hedge
trimmer in a dry and frost-proof place. Choose a
place that children are unable to enter.
10. Ordering replacement parts
Please quote the following data when ordering
replacement parts:
앬 Type of machine
앬 Article number of the machine
앬 Identification number of the machine
앬 Replacement part number of the part required
For our latest prices and information please go to
ww.isc-gmbh.info
11. Troubleshooting
The tool does not cut cleanly:
Check the blades and replace them if necessary.
In case of any other faults, please contact the ISC
Customer Service Center.
We draw express attention to the fact that we are
not responsible within the meaning of the
Product Liability Law for any damage caused by
our products if said damage results from
incorrect repair or the use of replacement parts
which are not original Einhell parts or parts
approved by us and the repair is not carried out
by the ISC Customer Service Centre.
Anleitung_GCGS_18_S:_ 14.12.2006 15:21 Uhr Seite 9