![background image](http://html1.mh-extra.com/html/gardenline/flx-tbs-1/flx-tbs-1_user-manual_3534629013.webp)
Preparing the tree pruner
13
If you would like to use the saw blade
1
, first attach it to the telescopic rod
3
as
follows:
1. Loosen the wing nut
2
of the saw blade by turning it anticlockwise.
2. Attach the saw blade bracket to the telescopic rod (see
Fig. D
).
3. Slightly tighten the wing nut of the saw blade by turning clockwise.
4. Slide the saw blade all the way up to the clippers
9
.
5. Loosen the wing nut
10
of the clippers by turning it clockwise.
6. Fold the clippers all the way down.
7. Tighten the wing nut of the saw blade by turning it clockwise.
Setting the telescopic rod
Setting the length
To set the length, proceed as follows:
1. Open the safety lock
4
of the telescopic rod
3
(see
Fig. E
).
2. Set the telescopic rod to the desired length.
The telescopic rod can be extended from 2.29 m to 3.63 m.
3. Close the safety lock of the telescopic rod.
4. Please ensure that the screw is firmly tightened to the safety lock
4
. Otherwise
the telescopic rod
3
can slide downwards.
Setting the opening width of the clippers
The maximum opening width of the clippers is 28 mm. The opening width of the clip-
pers
9
is preset at 28 mm. In some cases it may be necessary to readjust this setting
after a few cuts.
To set the opening width, proceed as follows: (see
Fig. F
):
1. Pull the grip plate downwards a few centimetres.
2. Firmly hold the tension cable
11
and then slide the grip plate
5
back to the top.
You will then be able to see the knot in the tension cable.
3. Loosen the knot in the strap.
− If you wish to shorten the tension cable, tie a new knot above the old knot.
− If you wish to lengthen the tension cable, tie a new knot below the old knot.
4. Pull the grip plate downwards until you hit the knot.
5. Slide the grip plate up to the top again.
Содержание FLX-TBS-1
Страница 3: ...3 A 2 3 4 5 7 8 1 6 9...
Страница 4: ...4 D B C E F 4 2 10 9 11...
Страница 5: ...5 G 45...