196cc 4 Stroke Petrol Lawn Mower
AFTER SALES SUPPORT
e-mail: [email protected]
1800 909 909
MODEL No.: DM53E3-D196 • 10/2017 • 56979
(toll free)
AFTER SALES SUPPORT
(toll free)
196cc 4 Stroke Petrol Lawn Mower
e-mail: [email protected]
1800 909 909
MODEL No.: DM53E3-D196 • 10/2017 • 56979
24
25
Battery Charging
This lawnmower is equipped with electric start
and uses ALDI Xfinity 20V powered batteries to
start the product.
Battery Model 51314 is provided with the product .
All Xfinity 20V batteries are compatible including
model 55756.
The charger provided with this product is a
standard charger.
IMPORTANT. Before attempting to charge the
battery, check the charger
adaptor (41), plug pack charger (42), and the
battery (8) to ensure the charging equipment
matches the battery supplied. The components
are all labelled with component numbers.
NOTE: The battery pack (8) needs to be removed
from the lawn mower for charging.
CAUTION! The battery (8) may require charging
at first use. A full charge will require approximately
5-7 hours.
CAUTION! The working temperature of the
charging operation is 0°C to 45°C.
1. Connect the battery charger adaptor (41) into
the plug pack charger (42) (Fig Q).
2. Connect the plug pack charger (42) in to the
240V mains power outlet. A “green” light
indicates power (Fig R).
3. Slide the battery charger adaptor (41) onto
the battery (8) by aligning the guiding rails.
A click indicates the battery is fitted (Fig S)
4. The plug pack charger (42) light will change to
“red”. The battery is now in the charging process.
When the light returns to “green”, the battery (8) is fully charged. (Fig R).
NOTE: The power to the charger should be turned off when unattended,
with or without a battery inserted.
Battery Charging
Preparing for Operation
Mulch and Mowing
Using the mower without the hard catcher (43) attached; the lawn mower will
mulch as it cuts and and the fine grass clippings are distributed back onto the
grass surface without leaving piles of grass clippings.
WARNING:
Ensure the engine is NOT operating when undertaking this task.
1. Remove the hard catcher (43) by lifting the rear discharge guard and releasing
the catcher (43). (Fig T)
2. Lift the rear discharge guard (16), insert the mulching block (39) into
position, then release and close the rear discharge guard (16). (The
mulching block (39) is correctly in place when the circle tabs on the block
click into place at the bottom of the rear discharge chute (Fig U).
3. Ensure the side ejector cover (20) is in the closed position (Fig V).
Do NOT use the side discharge chute (20) when mulch and mowing.
Adding and Checking the oil
IMPORTANT: The engine of this lawn mower is packed with NO OIL in the
engine. Prior to starting the engine, Oil MUST be added to the sump of
the engine.
Failure to add sufficient oil will result in damage to the engine which is
NOT covered under the warranty of the lawn mower.
On a new lawn mower, the engine needs to be filled with 500ml of SAE 10W/30
engine oil. We recommend Gardenline® Full Synthetic 4 Stroke Oil.
Each time the lawn mower is used, the oil level should be checked and if low,
add sufficient oil to ensure the oil level is to the full mark on the dipstick.
1. Position the lawn mower on a flat and level surface. Clean the area
directly around the oil filler cap (24).
V.
U.
T.
Q.
S.
R.
CHARGING
POWER ON/FULLY
CHARGED
Preparing for Operation