1
）
The installation direction of shield is close to the
human during the operation process;see figure
①
;
2
）
Align the four-angle buckle of the shield at the
cutter head slot of the mower, press down to the
end and then rotate until it aligns at the four-angle
buckle of cutter head, see Figure
②
;
3
）
Install the anti-collision wire, push the sides of the
wire into the holes on both sides of the cutter
head. The bottom of the wire contacts the ground
in the correct installation method, see Figure
③
;
Notes: If no wire is installed, the blade may be
damaged when operating the mower;
Demonstration of wrong installation
1
）
Remove the nuts of mower cutter head, see
Figure
①
;
2
）
The blade base is installed reversely, see
Figure
②
;
3
）
The blade locknut is installed reversely, see
Figure
③
;
IV. Install the middle connecting rod of mower
and open the package of accessories (5): Middle
connecting rod of mower
1
）
Align the opposite-side nut slot of base to the
mower motor or the nut on the screw shaft. The
nuts of cutter head should remain in the original
position, see Figure
①
;
2
）
Install the blade in the base front blade slot. After
the successful installation, the cutter head screw
should expose 1/3 inches, see Figure
②
;
3
）
Install the blade locknut. Note that the nuts with
pattern are downward (the wrong installation will
make the cutter head fall down), see Figure
③
;
4
）
Tighten the blade locknut clockwise with a
wrench, see Figure
④
.
III. Install the blade base and blade, and open the
package of accessories
(3)(4)
: Spare blade, a
blade base, a wrench, a blade locknut, work head
of mower
1
）
Align at the arrow marks on both ends of connect-
ing rod and insert it, see Figure
①
.
2
）
Align the plug at one end of the connecting rod
with the slot at the other end, see Figure
②
.
3
）
Referring to the rivets on the connecting rod, the
upper and lower rivet holes are inserted in a
straight line inserted, see Figure
③
.
4
）
Tighten the lock sleeve of rod in the locking
direction, see Figure
④
.
II. Install the mower shield and anti-collision
wire, and open the package of accessories
（
2
）
: A mower shield and a strip of anti-colli-
sion wire
2
1
X
1
3
2
1
3
2
2
3
4
Demonstration of wrong installation of mower
shield:
1
）
The shield is mounted in the opposite direction of
the handle;
2
）
The bottom of the anti-collision wire is installed
reversely without contact with the ground;
X
X
X
4
1
