7.
Examine the SHELF to find the holes for the remaining CROSS DOWELS.
With the holes facing down, slide the SHELF between the SIDE PANELS,
lining up the holes in the sides with the holes in the PANELS.
8.
For each corner, insert a CROSS DOWEL into the hole in the bottom of the
SHELF, making sure the hole in the CROSS DOWEL is pointed out. Place a
BOLT through the hole on the outside of the SIDE PANEL and through the
holes in the SHELF and the CROSS DOWEL (
Fig. 5
).
9.
With the frame now assembled, fully tighten all BOLTS.
Installing the Cross Cables
10.
Locate the predrilled holes in the back corners of the assembled frame. For
each ANGLE BRACKET, line up the side with 1 hole with a hole in the frame,
then insert 2 SCREWS through the holes in the other side (
Fig. 6
).
11.
Use the HEX KEY to screw two BANJO SCREWS into the open holes in
the top ANGLE BRACKETS. Tighten them until you can no longer see the
threads (
Fig. 6
). Insert the remaining BANJO SCREWS into the bottom
ANGLE BRACKETS, leaving some of the threads
showing so you can use them to tighten the CABLES
later.
12.
Feed the open end of a CABLE through the hole in
a top BANJO SCREW, pulling until the ball is directly
against the SCREW (
Fig. 6
). Insert the other end of the
CABLE through the bottom SCREW on the opposite
side of the frame. Starting with some slack in the
CABLE, use your HEX KEY to tighten the SCREW until
there is just a little bit of tension in it.
13.
Repeat Step 12 to attach the other CABLE. With both
CABLES in place, use your HEX KEY to make sure they
are equally tightened to the point where the sides of
frame are parallel to each other and perpendicular
to the ground. This will strengthen your frame so it
doesn’t sway when you move it.
Important:
Do NOT
overtighten the CABLES as this may cause the frame
to crack.
Tips
• If you do not want to use the stand with a Low Bamboo LED Grow Light Garden, the Galvanized Tray is sold separately
(8597905) and can be placed on top for additional shelf space.
• If using with a Low Bamboo LED Grow Light Garden (sold separately), we recommend securing the assembly to a wall for
stability.
CROSS DOWEL
insert
BOLT
through
here
Figure 5
Figure 6: Back of Frame
CABLE
ANGLE CONNECTOR, BANJO SCREW
