Fixture Use and Safety
• Use the power cord only with a properly
grounded electrical outlet or power strip. Do
not use with a two-plug outlet or extension
cord unless the adapter you use is properly
grounded.
• Always turn off the power to the Light
Fixtures when inserting, adjusting or removing
Light Tubes. If you insert a Light Tube when
the power is on, it may trigger an auto safety
mechanism, resulting in the light shutting off.
If this happens, turn off the Fixture; make sure
the Light Tubes are fully seated in the tube
sockets; wait for thirty (30) seconds, then turn
the Fixture on again. This will reset the Light
Fixture so the lights operate normally.
• If water is spilled near the power source,
unplug the unit before you wipe up the
water.
• Do not put objects on top of the frame
or on Light Fixtures.
• For on/off manual control of your lights,
use the switch located on the Light Fixture.
Installing and Adjusting Light Tubes
Step 15.
Unhook the Chains from the Light
Fixture and place the Fixture upside down on
the Poly Tray. This will reveal the Light Tube
sockets (Fig. 8). Then, take a fluorescent Light
Tube and find two pins on each end of the
Tube. Slide the pins into the tube sockets, then
rotate the Tube 90 degrees until it “locks” into
place, revealing the dimple guide mark on the
end of the Tube (Fig. 8). This guide mark indi-
cates proper placement of the Light Tubes
inside the sockets. Install three Light Tubes per
Fixture.
Installing the Tubes correctly will ensure
they produce the optimum amount of light.
Step 16.
Turn the Light Fixtures upright
and reconnect them to the Ball Chains.
Guide the power cord through the bars and
down one side of the frame, making sure they
don’t interfere with your ability to raise and
lower the lights.
Hook the Split Rings around the
“T”- shaped tabs to hang the Fixture.
Fig. 6
Turn Fixture upside down to
expose tube sockets.
The dimple guide
mark indicates the tube
pins are positioned properly
inside the sockets.
Pull chain in a horizontal direction.
Fig. 7
“Lock”
chain into
the Cleat
A1
Side Frame
A3
Slide the pins down into the tube
s o c k e t s t h e n r o t a t e 9 0 d e g r e e s u n t i l
the dimple guide is positioned at top.
Fig. 8
-3-
-6-
