REPLACING THE NYLON CORD
Check to see if the nylon head is damaged before replacing the cord. If you can see serious
damage, you must replace the complete nylon head.
•
Stop the engine.
•
Open the nylon head by pushing on the catch, Fig 13 and twisting the cover anti
•
Pull the bobbin out of the nylon head and take out the rest of the nylon cords.
•
Cut the cords, 2.4mm Ø and 5 meters long into two equal lengths.
•
Make a loop folded at one end of each of the two nylon cords and insert these into the two holes provided on
the bobbin, Fig 14.
•
Wind the lines together clockwise maintaining an even and fir
twist the cords.
•
After winding the cord, insert both ends into the notches on the bobbin, Fig 15.
•
Introduce each end of the cords into the holes provided Fig 16. The cords should stick out appx 15 cm either
side.
•
Pull the cords to free them from the notches and refit the spool cover.
Never use a cutting device other than those supplied by the manufacturer. (Steel cord is never allowed) A
use original spare parts in order to benefit from continuous warra
USING THE BRUSH CUTTER
CHOOSING THE CUTTING DEVICE
Choose the most suitable cutting device for the job to be done, according to these general
indications:
•
The cutting line head
can eliminate tall grass
•
The 3-point blade
is suitable for cutting brushwood and small shrubs up to 2 cm
CUTTING LINE HEAD
•
Cut the grass in 1.5 metre widths, keeping the machine well balanced.
Fig 13
catch
Fig 15
Check to see if the nylon head is damaged before replacing the cord. If you can see serious
damage, you must replace the complete nylon head.
Open the nylon head by pushing on the catch, Fig 13 and twisting the cover anti-clock wise.
Pull the bobbin out of the nylon head and take out the rest of the nylon cords.
Cut the cords, 2.4mm Ø and 5 meters long into two equal lengths.
Make a loop folded at one end of each of the two nylon cords and insert these into the two holes provided on
Wind the lines together clockwise maintaining an even and firm tension onto the bobbin, being careful not to
After winding the cord, insert both ends into the notches on the bobbin, Fig 15.
Introduce each end of the cords into the holes provided Fig 16. The cords should stick out appx 15 cm either
Pull the cords to free them from the notches and refit the spool cover.
Never use a cutting device other than those supplied by the manufacturer. (Steel cord is never allowed) A
use original spare parts in order to benefit from continuous warranty.
Choose the most suitable cutting device for the job to be done, according to these general
can eliminate tall grass and non-woody vegetation.
is suitable for cutting brushwood and small shrubs up to 2 cm in diameter.
widths, keeping the machine well balanced.
Fig 14
Fig 16
Check to see if the nylon head is damaged before replacing the cord. If you can see serious traces of wear or
clock wise.
Make a loop folded at one end of each of the two nylon cords and insert these into the two holes provided on
m tension onto the bobbin, being careful not to
Introduce each end of the cords into the holes provided Fig 16. The cords should stick out appx 15 cm either
Never use a cutting device other than those supplied by the manufacturer. (Steel cord is never allowed) Always
in diameter.
