16
6. When firing occur, push in the choke knob
and pull the starter again to start the engine.
7. Allow the engine to warm up with the throttle
lever pulled slightly.
Before you start the engine, make sure the
saw chain is not contacting anything.
■
CHECKING OIL SUPPLY
After starting the engine, run the chain at
medium speed and see if chain oil is scattered
off as shown in the figure.
(1) Chain oil
The chain oil flow can be changed by inserting
a screwdriver in the hole on bottom of the
clutch side. Adjust according to your work
conditions.
(1)
Chain oil flow adjusting shaft
(2) Rich
(3) Lean
The oil tank should become nearly empty by
the time fuel is used up. Be sure to refill the oil
tank every time when refueling the saw.
■
ADJUSTING CARBURETOR
The carburetor on your unit has been factory
adjusted, but may require fine tuning due to
change in operating conditions.
6.
Operation
