Gardena SILENO+ R160Li, Руководство оператора

Страница: 43 / 52

Symptoms Cause Action
Both the mowing
and charging times
are shorter than
usual.
The battery is spent. Replace the battery. Refer to
Battery
on page 33.
The product is
parked for hours in
the charging sta-
tion.
The product has an inbuilt standby peri-
od according to the Standby time table.
Refer to
Timer and Standby on page
29.
No action.
The hatch has been closed without the
START button first being pressed.
Open the hatch, press the START but-
ton and then close the hatch.
Uneven mowing
results.
The product works too few hours per
day.
Increase the mowing time. Refer to
To
calculate the timer setting on page 22.
SensorControl senses that the lawn
have been mowed more than it actually
has. Increase the intensity level in the
SensorControl. If this does not help,
turn off the Sensor control. Refer to
SensorControl on page 23.
The How often? setting is incorrect in
relation to the layout of the work area.
Check that the correct How often? val-
ue is selected.
The shape of the work area requires
the use of
Area 1-3 for the product to
find its way to all remote areas.
Use
Area 1-3 to steer the product to a
remote area. Refer to
Lawn Coverage
on page 24.
Work area too large. Try limiting the work area or extending
the work time. Refer to To do the timer
settings on page 22.
Dull blades. Replace all the blades. Refer to To re-
place the blades on page 32.
Long grass in relation to the set cutting
height.
Increase the cutting height and then
successively lower.
Accumulation of grass by the blade
disc or around the motor shaft.
Check that the blade disc rotates freely
and easily. If not, screw off the blade
disc and remove grass and foreign ob-
jects. Refer to
Clean the product on
page 31.
6.6 Find breaks in the loop wire
Breaks in the loop wire are usually the result of
unintentional physical damage to the wire such
as when gardening with a shovel. In countries
with ground frost, also sharp stones that move in
the ground can damage the wire. Breaks can
also occur due to the wire being stretched
excessively during installation.
Mowing the grass too low right after the
installation can damage wire insulation. Damage
to the insulation may not cause disruptions until
several weeks or months later. To avoid this,
always select the maximum cutting height the
first weeks after installation and then lower the
height one step at a time every second week until
the desired cutting height has been reached.
1025 - 001 - 23.01.2019 Troubleshooting - 43