en
15
4.2 To clean the battery and the battery charger:
The surface and the contacts of the battery and the battery charger must
be clean and dry before the battery is connected to the battery charger.
v
Do not use running water.
4.2.1 To clean the battery:
v
Occasionally clean the ventilation slots and the terminals on the battery
using a soft brush that is clean and dry.
4.2.2 To clean the battery charger:
v
Clean the contacts and the plastic parts with a soft and dry cloth.
5. STORAGE
5.1 To put into storage:
The product must be stored away from children.
1. Turn the safety key
(19)
to position 0 and remove it to prevent the battery
from discharging.
2. Remove the battery.
3. Charge the battery.
4. Empty the grass catcher box
(23)
.
5. Clean the mower, the battery and the battery charger
(see 4. MAINTENANCE).
6. Store the mower, the battery and the battery charger in a dry, enclosed
and frost-free place.
5.1.1 Storage position to save space [ Fig. S1 ]:
1. Loosen both wing nuts
(7)
.
2. Fold the upper handlebar
(4)
downwards onto the mower.
Make sure that the cable is not trapped between the upper and lower
handlebar, otherwise the cable may be damaged.
6. TROUBLESHOOTING
DANGER!
Cutting injury due to the blade!
Risk of cut injury due to accidental starting.
v
Use gloves.
v
Wait for the blade to stop.
v
Remove the safety key.
v
Remove the batterie.
6.1 To replace the blade [ Fig. T1 / T2 ]:
DANGER!
Risk of physical injury!
Risk of cutting injuries if a damaged or bent knife or one with
unbalanced or chipped cutting edges rotates.
v
Do not use the mower when the blade is damaged, bent, out of
balance or has chipped edges.
v
Do not regrind the blade.
The GARDENA spare parts are available from your GARDENA dealer
or from the GARDENA service.
v
Only use an original GARDENA Replacement blade
Art. 4121
For safety reasons, we recommend that the blade be replaced by
GARDENA Service or by an authorised GARDENA dealer.
1. Insert a screwdriver into one of the provided holes
(28)
at the bottom of
the housing.
The screwdriver thus serves as a stop for the blade.
2. Unscrew the blade bolt
(29)
.
Make sure that the spacer
ö
is not damaged when applying the force.
3. Remove the blade bolt
(29)
and the washer
ä
.
4. Remove the blade
ß
32
32
.
5. Put the new blade
ß
32
32
on the mower. The inscription on the knife
(this side to grass) must be visible.
6. Put the washer
ä
and the blade bolt
(29)
on the mower.
7. Screw the new blade
ß
32
32
tight with the blade bolt
(29)
(tightening torque is
15 – 20 Nm). Do not over-torque.
Make sure that the spacer
ö
is not damaged when applying the force.
8. Pull the screwdriver out of the mower.
Make sure that the screwdriver is removed before restarting the mower
again.
6.2 Troubleshooting table:
Problem
Possible Cause
Remedy
Engine is blocked
Obstacle blocks the motor.
v
Remove the obstacle.
Cutting height is too low.
v
Increase the cutting height.
Loud noises, the mower
is rattling
Screws on motor, its fixing
or on the mower chasing are
loose.
v
Let the screws be tightened
by an authorised specialist
dealer or the GARDENA
Service.
Mower runs unevenly or
vibrates strongly
Blade is damaged or worn.
v
Replace the blade.
Blade bolt is released.
v
Tighten the blade bolt.
Blade is very dirty.
v
Clean the mower. If this does
not solve the problem, con-
tact the GARDENA Service.
Lawn is not cleanly mowed
Blade is blunt or damaged.
v
Replace the blade.
Cutting height is too low.
v
Increase the cutting height.
Mower does not start or
stops.
LED
(L1)
blinks green
[ Fig. O4 ]
Battery is empty.
v
Charge the battery.
Mower does not start or
stops.
Error-LED
(Wp)
lights red
[ Fig. O4 ]
Battery temperature is outside
the permissible temperature
range.
v
Wait until the battery
temperature is between
0 °C – + 45 °C again.
There are drops of water or
moisture between the battery
contacts.
v
Remove the water drops or
moisture with a dry cloth.
Obstacle blocks the motor.
v
Remove the obstacle.
Mower does not start or
stops.
Error-LED
(Wp)
blinks red
[ Fig. O4 ]
Mower is defective
v
Contact the GARDENA
Service.
Mower does not start or
stops.
Error-LED
(Wp)
does not
light [ Fig. O4 ]
Battery is not put completely
into the battery holder.
v
Put the battery completely
into the battery holder until
it audibly engages.
Safety key is not turned to
positon
1
.
v
Turn the safety key to
position
1
.
Battery is defective.
v
Replace the battery.
Mower is defective.
v
Contact the GARDENA
Service.
Charging is not possible.
Battery charge indicator
(Lc)
lights continuously green
[ Fig. O3 ]
Battery is not slid onto the
charger correctly.
v
Slide the battery onto the
charger correctly.
Battery contacts are dirty.
v
Clean the battery contacts
(e. g. by connecting and dis-
connecting the battery several
times. Replace the battery if
necessary.
Battery temperature is outside
the permissible temperature
range.
v
Wait until the battery
temperature is between
0 °C – + 45 °C again.
Battery is defective.
v
Replace the battery.
Charging is not possible.
Battery charge indicator
(Lc)
does not light
[ Fig. O3 ]
Mains plug of the charger is
not plugged in correctly.
v
Insert the mains plug com-
pletely into the mains socket.
Mains socket, mains cable or
charger is defective.
v
Check the mains voltage.
Let the charger be checked
if necessary by an authorised
specialist dealer or the
GARDENA Service.
NOTE:
Repairs must only be done by the GARDENA service departments or
specialist dealers approved by GARDENA.
v
For any other malfunctions please contact the GARDENA service
department.
14632-20.960.02.indd 15
14632-20.960.02.indd 15
25.07.22 10:57
25.07.22 10:57
