Gardena 2403, Руководство по эксплуатации

Страница: 5 / 15

13
GB
Cutting position
Park position
5
5
8
F
Starting your Turbotrimmer :
Trimming along lawn edges
and in awkward places :
Filament feed (Tip mechanism
for automatic filament feed) :
1. Press the start button
F
on the handle
8
.
The Turbotrimmer starts.
2. Release the start button
F
on the handle
8
.
The Turbotrimmer switches off.
1. For vertical cutting, loosen the tightening
nut
B
, turn the additional handle
A
180 °
and then tighten the nut
B
again by hand.
2. Swivel the plant guard
5
backwards to
the park position until it clicks into place.
3. Lift the Turbotrimmer by the handle
8
and additional handle
A
and turn to the
cutting position.
4. When trimming between paving stones,
hold the Turbotrimmer so that the cutting
filament moves slightly above the paved
ground.
The filament is lengthened automatically when the motor is
running using a tip mechanism. A clean cut is only achieved
with the maximum filament length.
1. Leave the motor running.
2. Hold the cutting head
2
parallel to the ground and tap the fila-
ment cassette
G
of the Turbotrimmer on the ground several
times in succession (approx. 3 times) (avoid applying sustained
pressure to the Turbotrimmer).
The filament is lengthened automatically. Listen for the audible
switching action. The filament limiter
H
adjusts the filament to
the correct length.
5. Maintenance
There is a risk of injury from the cutting filament !
V
Always unplug the mains plug of the Turbotrimmer be-
fore carrying out maintenance work !
Risk of injury and risk of damage to property !
V
Never clean the Turbotrimmer under running water or
with a water jet (in particular a high pressure water jet).
The ventilation slots must always be free of dirt.
v
Remove any grass and dirt from the
cover
1
and ventilation slots
I
after
each use.
A
B
8
2
G
G H
Risk of injury !
Risk of injury !
Cleaning the cover
and ventilation slots :
I
1