Insert the battery in the
Programming Unit :
Insert the battery in the
Control Unit :
B
C
D
E
A
0
7
9
8
6
15
GB
Battery condition in the Control Unit :
If the battery capacity is exhausted while the Control Unit is con-
nected, then the symbol
Batt. ext.
will start to blink as soon as
data has been transferred
(Read)
and continues blinking until
the Control Unit is disconnected from the Programming Unit.
The battery of the Control Units must be changed.
If the battery is not replaced and the Control Unit is connected
to an Irrigation Valve, no watering programmes will be executed.
Manual watering using the
ON / OFF
key of the Control Unit is
no longer possible.
If left idle for 2 minutes, the Programming Unit switches to stand-by
mode and blanks the display. The image returns after any key is
touched. The main level is shown (time and weekday).
4. Putting into Operation
A programming aid in the form of a sticker is supplied with the
Programming Unit.
v
Stick the programming aid sticker onto the opposite side of the
handle to the battery compartment.
v
Label the Control Units with the self-adhesive labels (1 to 12).
This ensures that the Control Units match the Control Units
on the watering plan.
Before programming, you must insert a 9 V monoblock battery
in both the Programming Unit and the Control Unit.
1. Slide down the cover
6
on the back of the handle
7
and if
necessary remove the flat battery.
2. Insert the new battery
8
in the correct position (according to
the + / – markings in the battery compartment
9
and on the
battery
8
).
3. Press the battery
8
into the battery compartment
9
.
The battery contacts
0
touch the contact springs
A
.
4. Close the battery compartment
9
by sliding the cover
6
back
into place.
Inserting a new battery resets the unit. The time is set to
00::0000
and the day is not set.
TTIIMMEE
and
00
for hours flash on the display.
You must now set the time and day (Refer to 5. Operation
“Setting Time and Day” ).
1. Insert the battery
B
in the correct position
(according to + / – markings in the battery
compartment
C
and on the battery
B
).
2. Press the battery
B
into the battery
compartment
C
.
The battery contacts
D
touch the contact
springs
E
.
The Control Unit is now ready for use.
Automatic energy-saving
stand-by mode
Stick programming aid sticker
onto Programming Unit :
Stick self-adhesive label
onto Control Units :
