7
Step 9 – Attach Reflector Assembly to Studs
.
Support Heater.
.
Slide 3 Large Flat Washers over threaded end of
Studs.
.
Locate Reflector Assembly on 3 studs.
.
Install large flat washers on studs & securely tighten
wing nuts but do not over-tighten!
Step 10 – Connect Hose & Regulator to Cylinder
.
You
must
provide
propane
gas
and
propane cylinder. Use a
standard 20 lb. propane
cylinder only.
.
Use this heater only
with a propane vapor
withdrawal
supply
system. See Chapter 5
of the Standard for
Storage and Handling
of Liquefied Petroleum
Gas,
ANSI/NFPA
58.Your local library or
fire department will have this book.
.
A minimum supply pressure of 11.0 W.C. is required
for the purpose of input adjustment for propane gas.
.
The pressure regulator and hose assembly supplied
with the appliance must be used.
.
The installation must conform with local codes, or in
the absence of local codes, with National Fuel Gas
Code, ANSI Z223.1.
.
A dented, rusted or damaged propane cylinder may
be hazardous and should be checked by your cylinder
supplier. Never use a propane cylinder with a
damaged valve connection.
.
The propane cylinder must be constructed and
marked in accordance with the specifications for LP
gas
cylinders
of
the
U.S.
Department
of
Transportation (DOT).
.
Never connect an unregulated propane cylinder to the
heater.
.
Lift Cylinder Housing.
.
Screw regulator onto gas hose. Do not cross-thread.
.
Tighten securely.
.
Attach regulator to cylinder.
.
Complete attachment.
.
Install cylinder.
Standard 20 lb. tank
6 Req’d Large Flat Washers
3 Req’d Wing Nuts
