12
Technical data
Model
Rated Rating
Bar length (inch)
GPCS06
120V~60Hz 6.5A
8
Before starting up
Before commencing work, always check that the chainsaw works properly and is
safe to operate.
Using Bar and Chain Oil (available from your local hardware store) carefully fill the oil
tank to approximately halfway on the oil tank window, always maintaining close to
this level.
Checking the chain lubrication system, carefully switch the chainsaw on and hold it
above the ground. Be careful not to allow the chainsaw to touch the ground. For
safety reasons it is best to keep a clearance of at least 20 cm. If you see growing
traces of oil, the chain lubrication system is working correctly. If there are no traces of
oil at all, try cleaning the oil outlet hole located behind the bar and check the bar and
chain for debris blocking the flow of oil. Also make sure the oval shaped seal is in
place between the oil outlet hole and bar.
Check the chain tension and retention, if necessary.
Starting up the machine
1
）
Assembly of the telescopic chain saw/assembly of the telescopic tube
See Fig. B
Put the telescopic tube to the opening engine head, and then tighten the screw to the
engine head. You can loosen the locking knob for length adjustment completely and
push the telescopic tube to the desired length, finally tighten the locking knob firmly.
2
）
Assembly and use of the shoulder strap
See Fig. D
Use your thumb or fingers to squeeze the safety lock piece, put the hook to the hanging
part of the tool.
Move slide buckle to adjust the length of the shoulder strap. Adjust the length of the
shoulder strap to obtain a comfortable working position. A few practices swings without
starting motor should be made to determine correct balance.
Put the shoulder strap over your right shoulder. Carry the tool engine at the right side of
your body.
3
）
Adjustment of engine head
See Fig. E
Press the angle adjustment button for engine head adjustment and adjust the engine
head until it snaps into the desired position.
Содержание GPCS06
