6)
Slide one corner over the end of each tube. These prongs should point down or away from the screw holes thus
creating a little table.
7)
Repeat the entire procedure a second time with the third group of tubes that are the same as group one but have
no drill holes except for the one with the U-bolt.
8)
To complete assembly of the basket frame; place the original frame with drill holes back on the flat surface with its
drill holes still facing down and the prongs of the four corners facing up.
9)
Locate the four remaining 22” tubes. Place one over each of the four PVC corner prongs and snug tight.
10)
To complete the frame assembly pick up the second frame and position this frame such that its prongs are
directly above the four 22” tubes attached to the lower frame. Align the prongs with the open ends of the 22” tubes, make
sure your U-bolts are facing the same direction, now slide these assemblies together and snug all four tubes.
11)
Invert the rigid basket frame such that the screw-holes on the bottom of the box are now on top and visible. Locate
the double wall aluminum mast with stainless steel hose clamp. Loosen the stainless clamp on the 1 3/8” mast and pull the 1
¼” inner aluminum tube out from the 1 3/8” section approximately 10 ½”. Tighten the hose clamp to secure these two tubes
in place. Insert the larger or 1 3/8” end down through the “U” bolts until the mast rests on the flat surface and is even with
the frame. Tighten the “U” bolt closest to the flat surface. Now slightly tighten the second U-bolt.
4.2 Attaching the mesh to the basket
Locate the four mesh sections that are 24” x 26 ½ ”. Place the rigid basket on its side, any side.
1)
Place a single mesh piece over the frame. Align one edge over the 1/8” drill holes. Using four 5/16” self tapping screws
and washers secure the mesh to the 1” x 1” box beam using the nut driver supplied.
