Instructions For Floodlight
EN
Code: MYS14A1
Correct Disposal of this product
This marking indicates that this product should not be disposed with other household wastes throughout the EU. To prevent possible harm to the
environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources.
To return your used device, please use the return and collection systems or contact the retailer where the product was purchased. They can take
this product for environmental safe recycling.
EverFlourish Europe GmbH
Robert-Koch-Str. 4
66299 Friedrichsthal
Germany
Made in P.R.C.
IMPORTANT Read these instructions fully before using the Floodlight. Retain these instructions for future reference.
Main construction Data
Electric shock protection class:
Ⅱ
External light protection class: IP44
Rated voltage:220-240V~ 50/60Hz
Power cord: H05RN-F 2x1.0mm
2
General safety instructions
• Never look directly into the LED light source. The light emitted can contain the colour blue.
• To clean: Ensure that the floodlight is disconnected from the mains and cannot be unintentionally reconnected.
• Place only upon level and stable surfaces.
• Do not use near flammable materials.
• Do not use near paddling pools, fountains, ponds or similar water sources.
• Do not place in water or other liquids.
• Never operate with wet hands.
• Never cover the equipment.
• Never operate when the casing is open, or when the wiring casing is missing or damaged, or when the protective screen is defective.
• Never spray this unit, and never attempt to clean it with a steam pressure cleaner as this can damage the insulation and seals.
• Never attempt to repair this unit yourself. Repairs should only be carried out by the manufacturer or their authorised service personnel.
• If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard.
Connect the mains wire(see fig)
1. Open the installation base
2. Fix the installation base with fitting screws
3. Unscrew the cover of terminal box and connect the power cable into the terminal box
4. Install the screws (4pcs)
5. Switch the housing to fixed with the installation base
Wall mounting (see fig)
1. Do not mount on a surface prone to vibrations.
2. Punch according to the installation size and fix the bulkhead with suitable screws(not included). (fig 1)
Cleaning
Before cleaning the LED floodlight, disconnect the power cable and allow the floodlight to cool down suffi ciently,Clean with a dry or slightly moist, clean,
lint-free cloth and a mild detergent if required. Do not use cleaners that contain abrasives or solvents.
Maintenance
• Check the plug, power cable, and housing of the LED floodlight for damage before each use. If the lens is damaged it must be replaced immediately.
• Clean any dirt from the housing or the lens immediately, since it could cause overheating.
