Ganz ZN-BT3312, Руководство пользователя

Страница: 8 / 62

8 - User's Manual
Network Deployment
Setup the Network Camera over the Internet
This section explains how to configure the Network Camera to Internet connection.
1� If you have external devices such as sensors and alarms, connect them to the general I/O
terminal block�
2� Use the supplied RJ45 female/female coupler to connect the Network Camera to a switch�
Use Category 5 Cross Cable when Network Camera is directly connected to PC�
3� Connect the power cable from the Network Camera to a power outlet�
There are several ways to setup the Network Camera over the Internet � The first way is to setup
the Network Camera behind a router � The second way is to utilize a static IP � The third way is to
use PPPoE �
Internet connection via a router
Before setting up the Network Camera over the Internet, make sure you have a router and follow
the steps below�
1� Connect your Network Camera behind a router, the Internet environment is illustrated as
below� About how to get your IP address, please refer to Software installation on page 11 for
details�
IP address : 192.168.0.3
Subnet mask : 255.255.255.0
Default router : 192.168.0.1
IP address : 192.168.0.2
Subnet mask : 255.255.255.0
Default router : 192.168.0.1
LAN (Local Area Network)
Router IP address : 192.168.0.1
WAN (Wide Area Network )
Router IP address : from ISP
Cable or DSL Modem
POWER
COLLISION
LINK
RECEIVE
PARTITION
1
2 3 4 5
Internet
1
N�C�: No Connector
485B: RS485-
485A: RS485+
AC24V: Power in AC 24V
AC24V: Power in AC 24V
GND: Ground
DI : Digital Input
DO : Digital Output
+12V : Power, 12V DC
GND
DI
DO
+12V
POWER
COLLISION
LINK
RECEIVE
PARTITION 1 2 3
4 5
Ethernet switch
3
2 1