G&J Hall POWERBOR Series, Оригинальное руководство пользователя

Страница: 8 / 28

8
PB45 - W18XC1053 - Revised 230712
.
ELECTRICAL SAFETY Always carry the power tool properly with the carrying handles
Earthing / Grounding.
This power tool requires a ground or earth connection.
The power tool must be plugged into an outlet properly installed and grounded or earthed
in accordance with all local codes and regulations.
Never remove or tamper with the ground or earth prong in any way.
Do not use adaptor plugs.
If the tool should electrically malfunction or breakdown, grounding or earthing will provide
a low resistance patch to carry harmful electricity away from the user.
Power Cord
Never carry the power tool by its power cord or electrical hose.
Keep power cords away from heat, oil and sharp edges.
Never pull the power cord to disconnect it from the receptacle.
Always carry the power tool properly with the carrying handles provided.
Periodically inspect the power cord for damage,
If any damage is found the power tool should not be used until the damage has been
repaired by a qualified electrician.
A damaged power cord will increase the risk of electric shock.
Using the Power Tool Outside
Do not expose the power tool to rain or wet conditions, water entering the power tool will
increase the risk of electric shock.
When operating the power tools outside, if required, an extension cord rated for outdoor
use should be used.
These extension cords are rated for outdoor use and reduce the risk of electric shock.
Electrical Enclosure
The electrical components on this power tool are housed within the main body casting,
this and the side panels of the main body create an electrical enclosure.
The panels should not be removed except by a suitable trained or qualified electrician.
DUST EXTRACTION
This tool is intended for drill holes in ferrous metals, if using on materials such as cast
iron where dust might be created, suitable dust extraction should be used.
This is both to protect the operator and to protect the motor inlet from ingress of harmful
dust particles.
Operators should wear suitable dust masks if dust is created whilst working.