G&J Hall POWERBOR Series, Оригинальное руководство пользователя

Страница: 14 / 28

14
PB45 - W18XC1053 - Revised 230712
SETTING AND TESTING - USING THE SAFETY STRAP carry the power tool properly
A ratchet type safety strap is provided.
The power tool has 2 x „D‟ loop rings to allow
the hooks on the safety strap to be attached
securely.
Always ensure the strap is correctly fitted and
the machine is secure BEFORE starting the
motor unit.
The safety strap is used to reduce the risk of
injury in the case of a power supply or
electrical malfunction.
The strap will hold the power tool if the
electro-magnet looses its magnetic adhesion.
If the strap becomes damaged or lost, it must
be replaced BEFORE using the power tool.
DO NOT use the safety strap as an
alternative clamping method, the
electro-magnet should have good magnetic
adhesion at all times whilst using this power
tool.
„D‟LOOP
RATCHET
STRAP
The holder for the cutting tool is known as the
arbor. The arbor is designed to accept
Powerbor 3/4” Weldon shank annular cutters.
The Powerbor annular cutters normally have
two flats disposed at 90°to each other.
To mount the cutter.
First ensure the ejector pin is in place.
Align the flats with the two fixing screws.
Push the cutter up into the arbor until it stops.
Tighten the two fixing screws onto the cutter
flats with the hex keys supplied.
MOUNTING CUTTERS INTO THE ARBOR