G&G CYGG-080, Инструкция по эксплуатации

Страница: 17 / 24

13
5 ǀ MAINTENANCE
Always turn off the filter unit first and allow the hot surfaces to cool before performing any
maintenance or inspection. We also recommend securing the unit against unexpected start-
up.
If the filter unit discharges hazardous substances, always use appropriate personal
protective equipment according to the nature of the hazardous substance.
OTHER
MAINTENANCE
Emptying dust
containers
Regularly check the fill level of the dust container used on your model of cyclone
and, if full, empty the container into the place designated by the operator. We
recommend that you set the frequency of checking and emptying depending on
the conditions in which the filtration unit is operated.
MAINTENANCE OF
ELECTRICAL PARTS
Periodically or according to the operator's internal regulations , check that all
connectors are inserted and that the screws of electrical connections and
terminals are tightened . Perform these checks with the filter unit switched off.
Regularly check the insulation condition of all cables and the grounding
condition . In case of any damage, contact the electrical maintenance personnel
immediately.
Check the electric motor of the fan according to the instructions of their
manufacturers, given in
in separate manuals. The manuals are included in the delivery of the filter unit.
Maintenance of the electrical parts of the equipment may only be carried out by persons who
are properly trained and qualified.
REMOVAL
PORUCH
Reduced suction
effect
In case of reduced suction effect at the source, inspect and check:
- system settings, especially the fan
- pipes; dirt in the form of rags, crumpled newspapers, etc. could have got stuck
here.
FAILURE POSSIBLE CAUSE SOLUTION
Fan failure on start-up Wrong fan wiring. Improper wiring.
Check the warm electric motor. It is
necessary to check the electrical
connection of the fan.
Unbalanced rotating components
Check balance of
rotating components
(especially rotor
fan).
The cyclone vibrates
considerably
Adhesive bonding of the
seams at fan rotor
Check rotor fan
and if necessary,
remove any deposits.