G&D DP1.2-Vision-Fiber, Инструкция по установке и эксплуатации

Страница: 105 / 152

Configuration
G&D DP1.2-Vision-Fiber · 26
English The basic operation of the on-screen display (see page 26) and the web application
Config Panel (see page 29) is described on the following pages.
Operating the on-screen display at the console
The on-screen display (OSD) – just like the web application Config Panel , which is
described on the following – can be used to change the configuration of the KVM
extender.
The on-screen display can be opened by pressing a configured hotkey at the user
module. You can view and edit the settings of the KVM extender only in the remote
OSD of the computer module .
Showing the on-screen display at the console
How to open the on-screen display:
1. Press
Ctrl+Num
(standard) to open the on-screen display.
Function Default setting Page
Changing the colour of the information display light green 51
Information display temporary 52
Adjusting the transparency of the on-screen display average transparency 53
Automatic closing of the OSD after inactivity disabled 54
Changing the position of the information dispaly left upper corner 55
Changing the position of the on-screen display centred 55
NOTE: Use the
remote hotkey
(default:
Ctrl
+
Num
) at the console to open and config-
ure the remote OSD of the computer module and the
local hotkey
(default:
Alt
+
Num
)
to open and configure the local OSD of the user module.
During the starting process of the user module, the settings of both hotkeys are
shown (see
Starting process
on page 18).