Gamma M2-W, Инструкция

Страница: 11 / 59

hold down the M-button (the instrument must have been switched off be-
forehand) until CL appears and then release the button. To permanently
clear the memory, press the M-button while CL is flashing. Individual values
cannot be cleared.
5. error Messages/Troubleshooting
If an error occurs during a measurement, the meas-
urement is discontinued and a corresponding error
code is displayed (picture: error no. 2)
error No. Possible cause(s) / Solutions
ERR 1 No pulse has been detected. Cuff may be positioned
incorrectly.
ERR 2 The arm was moved during the measurement. Repeat
the measurement, keeping your arm still.
ERR 3 Inflation of the cuff took too long. The cuff is not po-
sitioned correctly Check that the cuff is correctly con-
nected and is not too loose.
ERR 5 The measuring signals are inaccurate and no result can
therefore be displayed. Read through the checklist for
performing reliable measurements and then repeat
the measurement.*
HI The pressure in the cuff is too high (over 300 mmHg)
OR the pulse is too high (over 200 beats per minute).
Relax for 5 minutes and repeat the measurement.*
LO The pulse is too low (less than 40 beats per minute).
Repeat the measurement.*
*Please consult your doctor, if this or any other problem occurs repeat-
edly.