Safety Precautions
Please keep this User Guide for future consultation. If you sell the unit to another user, be
sure that they also receive this instruction manual.
Caution: For added protection mount the fixtures in areas outside walking paths, seating ar-
eas, or in areas were the fixture might be reached by unauthorized personnel.
Before mounting the fixture to any surface, make sure that the installation area can hold a
minimum point load of 10 items the device’s weight.
Fixture installation must always be secured with a secondary safety attachment, such as an
appropriate safety cable.
Never stand directly below the device when mounting, removing, or servicing the fixture.
From a ceiling, or set on a flat level surface (see illustration below). Be sure this fixture is kept
at least 0.5m (1.5ft) away from any flammable materials (decoration etc.).
Always use and install a safety cable as a safety measure to prevent accidental damage
and/or injury in the event the clamp fails.
DO NOT connect the device to any dimmer pack.
During initial start-up some smoke or smell may arise. This is a normal process and does not
necessarily mean that the device is defective, and it will decrease gradually within 15 minutes.
∙Don’t try to modify the fixture without any instruction by the manufacturer.
∙Warranty is voided if there are any malfunctions from not following the user manual while op-
erating or any hazardous operation, like shock short circuit, electronic shock, lamp broken,
etc.
TX-6 Z– GAMMA LED Vision
Page 5 of 19
