Instruction Manual : 10’ BLIND TOWER
19
STEP 11
FIGURE 11
FIGURE 12
STEP 12
11. Begin assembly of the ladder by first sliding
together the bottom and top ladder sections (7, 8)
as shown. SEE FIGURE 11.
Secure the ladder sections together by attaching
the two ladder hand rails (10) to the four holes on
each side of the ladder using four 1/4-20 X 2-1/4 IN
bolts (23), three orange plastic washers (27) and 1/4-
20 nuts (29) for each hand rail. SEE FIGURE 11.
Attach the adjustable ladder feet (9) to the bottom
ladder section (7) using a 1/4-20 X 1-3/4 IN bolt
(21) and 1/4-20 nut (29) for each foot. It is easiest
to adjust the ladder level later if you use the top
adjustment hole now as shown. SEE FIGURE 11.
Securely tighten all loose hardware at this time.
12. Tip the platform on edge as shown and insert
the four leg assemblies into the leg-to-platform
attachment parts (11). Pay attention to the
orientation of the leg so that the foot plate is angled
correctly to sit flat on the ground. For the two upper
legs, attach a brace-to-leg attachment bracket (32)
to each leg and secure the parts together using a
1/4-20 X 2-1/2 IN bolt (22) and 1/4-20 nut (29). For
the two lower legs, the right and left entry platform
braces (16, 17) must also be attached to the bolts in
this step. SEE FIGURE 12.
10
23
27
29
21
7
29
8
22
32
11 29
12
17
9
16
