Instruction Manual :
PLATFORM 2-MAN LADDER STAND
26
BEFORE EACH USE PERFORM THE FOLLOWING:
• Inspect all webbing, rope, cord, and strap assemblies for
wear or damage.
• Inspect cables and/or cable ends for damage or kinking.
• Inspect all hardware and chain components for damage or
wear.
• Inspect for any structural damage to product. (If any exists
stop use immediately and call RETI Customer Service.)
• Inspect all nut and bolt assemblies to be certain none are
loose.
• Inspect for any missing parts.
• Lubricate all pivot and slide together points with powder
graphite, petroleum jelly or silicone spray to prevent noise,
wear and rust.
• Inspect entire product for any rust, corrosion, cracks,
freezing, excessive heat or rotting damage that may effect
the safety of your product. Discard any questionable
product.
• Inspect entire product for any structural damage - pay
close attention to all weld locations. (Discard product if any
damage is found.)
• Using correct wrenches inspect all nut & bolt assembly
locations and snug up any that may be loose. Be careful not
to crush tubing when tightening!
• Inspect and check operation of all cables, cable ends, cord,
rope, webbing, and strap or chain assemblies. Replace
with RETI original replacement parts any item or assembly
that shows signs of wear, damage, kinking, or functions
incorrectly.
• Inspect seat for damage or wear. Replace any seat with
factory new that shows signs of structural damage or wear.
• Never modify your stand in any way by making repairs,
replacing parts, or altering by adding or attaching anything
to it except if explicitly authorized in writing by the
manufacturer.
INSPECTION AND MAINTENANCE
