6
Connect the larger end of the
Connector Hose (with the red
button) to the Control Unit.
Make sure you hear it click.
To disconnect, simply press
the red button and remove
the connector from the
Control Unit.
7
Apply the selected Wrap (consult the Use Guide accompanying each Wrap for
application instructions). To ensure proper performance of the System, it is important
to use ATX Series Heat Exchangers in your Wrap.
Caution
:
•
The Wrap is not sterile. Do not place directly against open wounds, sores,
rashes, infections, or stitches. The Wrap may be applied over clothing or
dressing.
•
To ensure best fit, be sure the Wrap is completely deflated prior to each
application.
If you have any problems with the set-up of your GRPro System, in the U.S. call
Game Ready Customer Service at 1.888.426.3732 (+1.510.868.2100); from outside
of the U.S. please contact your local distributor.
Warnings
:
•
Follow the treatment recommendations of your health care practitioner
for the use of this device.
•
Improper placement or prolonged use of the GRPro could result in tissue
damage
•
For additional warnings and precautions, please refer to pages 12 & 13
of this manual.
8
Connect the smaller end of the Connector Hose (with a blue or gray button) to the
Wrap. Make sure you hear it click. To disconnect, simply press the blue or gray button
and remove the connector from the Wrap.
9
Set your target temperature (displayed in the Target Temperature window) by
turning the knob. Turning the knob clockwise, towards 3 snowflakes, will
provide more cold therapy. Turning the knob counter-clockwise, towards 1
snowflake, will provide less cold therapy.
4
Place the Control Unit in the location where you plan to use it. The Control Unit should
only be used in the upright orientation as shown. The Control Unit will leak if placed on
its side.
Disconnect
Button
Connector Hose
to Wrap
2
Add water to fill-line indicated on label within the reservoir. DO NOT OVERFILL. Add
ice to top of reservoir.
3
Close the ice box door. Make sure you hear it click.
Click
EN-7
EN-6
Disconnect Button
Click
5
Connect the AC Adapter to the receptacle on the end panel of the Control Unit, then
plug the AC Adapter into a grounded electrical outlet. The power indicator light (orange
color) on the Control Unit should illuminate. Press the power button. The screen
should light up and theaControl Unit should beep twice. The power indicator light
should turn from orange to
green. If you do not see these
indicators, refer to “Control
Unit will not turn on” on page
17 of the Troubleshooting
Guide in this manual.
Note
: The Control Unit should
be turned on prior to attaching
a Wrap.
AC Adapter
to electrical outlet
SUPERSEDED
