INSTALLING THE TOUCH SCREEN
5 / 9
INSTALLATION - Power
It is recommended to have at least 5A avaialble to power the screen. The input is 11-16Vdc.
1.
It is recommended to wire the screen to ignition or a timer to prevent the battery from draining.
2.
Make sure power is off before performing any install steps.
3.
Bare wire power cable installation:
4.
Attach the red cable to the positive power source.
Attach the black cable to the ground.
INSTALLATION - Mounting
It is required to secure and zip-tie the ports listed on page 4, to guarantee performance.
1.
If mounting to a Gamber-Johnson clevis, use the Hanging Bracket to place the screen and
2.
support the weight while attaching the Mounting Bolts included with screen.
If mounting to other equipment, remove and toss the Hanging Bracket and screws.
3.
RED WIRE
- to power
BLACK WIRE
- to ground
Hanging Bracket
Mounting Bolts and washers (x4)
If turning on power to the system, the mounting surface (metal) may be hot to the touch.
WARNING:
Hot Surface, Do Not Touch IEC 60417-5041(DB 2002-10)