3 / 5
Adjusting Notepad™V for computer
Pull to open deck
Unlock and turn lock body
Optional Vinyl Caps
Adjustment Screw
If the latch on Notepad™V is locked,
unlock the unit with the supplied keys.
All Notepad™V's are keyed alike.
Unlatch by turning the lock body
clockwise 90 degrees.
Loosen adjustment screws securing
front clips, rear clips and side clips
enough to raise them and move them in the slots.
Eight Vinyl Caps are included in hardware bag
to place over clips to protect computer if needed.
(Zero Edge Side Clips 7160-0250-02, are used without caps)
Place the computer on the Notepad™V deck
Slide the computer tight against the Front Clips.
The Front Clips can be adjusted side-to-side and.
also have a slight amount of vertical adjustment.
The Flat and Offset clips may also swap positions,
with the offset clip overlapping the fixed deck to
accomodate shorter depth computers.
Slide the computer against the Side Clips on the fixed deck.
Adjust the Side Clips side-to-side to avoid any needed ports
and lower them so the tab will just clear the top of
the computer and tighten. A snug fit is preferred.
Pull the lock side of the Notepad™V
to the right to open the deck.
Push the right side of the Notepad™V in
until the right Side Clips touch the computer.
Adjust the right Side Clips in the same
manner as the left side.
After pushing the unit together,
(compressing the computer between the
side clips) turn the lock body 90 degrees
counter-clockwise to secure the unit.
Adjust the Rear Supports side-to-side
and tighten.
Adjust the Rear Clips to prevent the
computer from moving back and tighten.
