page 4
Replacing the Battery
Batteries are available for purchase at www.gamasonic.com
MAINTENANCE
Clean the solar panels regularly with a damp towel to guarantee optimum performance. Do not
use any type of solvent for cleaning and be careful not to put too much pressure on the solar panels
while cleaning.
TROUBLESHOOTING
If your solar light does not come on as expected despite observance of all the instructions, please
try the following steps:
1. Make sure that the solar lamp is not being affected by any other light source.
2. Ensure the solar lamp is not positioned in the shade during the day.
3. Check that the batteries are installed correctly.
NOTE: The performance of the solar lamp will vary with the time of year. It will last longer when it
has had a full day in the sun rather than a day in overcast weather.
WINTERTIME TIPS: For optimal performance, be sure to remove any snow or debris
accumulation from solar panel(s). A solar panel free of debris will charge the batteries
much more efficiently.
WARNING: Please keep out of reach of children. Do not dispose of Li-Ion battery in the regular trash,
municipal waste stream or by fire as batteries may leak or explode. Do not open, short circuit, or
mutilate batteries as injury may occur. Preserve our environment by recycling Li-Ion batteries or
disposing of them in accordance with local, state and federal regulations. Do not mix old and new
batteries.
HIGH
LOW
OFF
After several years of use, the battery may need replacing.
1. Disconnect the top (A) by removing the two screws attaching it to the fixture (B).
2. Move the switch to the OFF position and remove the bulb.
3. Remove the two screws holding the silver reflector and detach the reflector from the top (A).
4. On the underside of the reflector, loosen the screw and move the battery bracket to the side.
5. Unclip the battery connector and remove the battery.
6. Make sure the new battery is a 3.2V/1500mAh Li-Ion battery with matching connector
(Item# GS32V15).
7. Clip in the new battery and secure it in the compartment using the battery bracket and screw.
8. Reverse steps 1-3 to re-assemble the lamp.
