Tools that are needed but not supplied with the high post solar lamp set are: a screw
driver, a wrench and an electrical drill that will be used to anchor the lamp base to the
ground.
Solar Lamp Post Location
For optimum light duration throughout the night, it is very important to mount your
solar lamp post in a spot where it will receive the maximum amount of direct sunlight
throughout the day.
Assembly Instructions
NOTE
: The following steps are for reference only. Consult your local hardware store
for the best installation method for your particular surface.
NOTE
: The solar light must be charged for two sunny days in the “ON” position for
best results.
GS-94S
1.
Turn the On/Off switch in the lamp head (A) to Low or High position
(Fig. 1).
2.
Use electric drill to make three holes into a solid surface no smaller
than the fastening screws (G). The holes shall be lined up with the
holes of the lamp base (F).
NOTE
: For installation in the ground where pouring concrete is not
preferred or possible, use our GS-3 EZ Lamp Post Anchor (sold
separately) to quickly and easily secure the lamp anywhere in your
yard.
3.
Put the fastening screws (G) into the drilled holes with their threaded
ends facing up.
4.
Place lamp base onto fastening screws and secure base with the nuts
using a wrench. Cover the bolts with the plastic covers provided.
5.
Make sure the lamp base (F) is stable before installing Part (E).
6.
Place part (E) on top of part (F) and tighten with the provided screws
using a wrench.
7.
Screw part (D) to part (E), part (C)
to part (D) and part (B) to part (C).
Fig. 1
Fig. 2
