page 3
NOTE: This Commercial Grade Solar Light
comes preinstalled with a 2 Inch adaptor. If you
are installing this post light on a 3 Inch outside
diameter post, please remove it [Fig. 1].
NOTE: If you are replacing an existing gas/
electric post light, you must consult a certified
technician to disconnect them before
installation.
Install the lamp onto your existing post. Using a
4mm hex key, tighten the set screws so they are
snug against the pole and the lamp does not
move.
[Fig. 2]
To control the operation of your lamp, locate
the toggle switch on the underside of the top
near where one of the arms mount. Move the
switch to the left or right to turn the lamp to
either high or low. The switch should match
the direction indicated on the sticker near
the switch to achieve the desired brightness
setting.
[Fig.3].
The Low mode setting lasts longer while
using a dimmer light, and the High mode
provides brighter light output for a shorter
duration of the light.
3. Installation Instructions
4. Operation Instructions
2" Adaptor
Removing included
adaptor
Fig. 1
Fig. 2
Fig. 3
Operation Switch
