page 3
1. Using the mounting bracket
as a template, mark where
the two holes will need to be
to hang your light.
2. Using a drill, make two holes
no larger than the anchors
where those marks are and
insert the wall anchors.
3. Place the bracket in line with
the holes and secure with
the provided screws. (make
sure the bracket is installed
so the two tabs are not
against the wall)
4. Install the lamp onto the
bracket making sure the two
tabs slide into the grooves on
the back of the lamp.
1. Make sure the lamp is in the OFF (O)
position (Fig. 1).
2. Detach the back of the lamp unit (B)
by removing the 2 screws at the
base of the lamp (Fig. 2).
3. Install the GS Solar LED bulb by
holding it at its base and twisting
clockwise (Fig 3).
4. Reassemble the unit by reversing
the above steps.
5. Make sure the High/OFF/Low switch
is in the ON (High or Low) position
(Fig. 1).
Operation Instructions
Installation Instructions (Fig 4)
Fig. 1
Fig. 2
SCREWS
Fig. 3
Fig. 4
