If you choose to vary from these instructions your warranty will be impaired
4
STEP 3
FRONT WALL
Lay down the doors with the sheets attached. Cap the sheets with the 3000mm
channels
F
. Use the door spacers
K
to make sure the door fits the gap (they sit
on top of the 'Z' door jambs
N
see diagram 1).
Drill and fix (rivet or screw) the channels at every second rib down through the top.
Attach the door spacers at each end through the 'Z' door jambs and channels.
Put three fixings underneath through the channels into the sheeting pan and the
top and bottom of the door spacers and 'Z' door jambs (see diagram 1).
Fit the padbolt
P
to the door strap on the outside of the door using wide
flange rivets or screws.
Channels will come short
of the ends of the sheeting by
10-15mm on all panels.
PADLOCK KEEPER
ASSEMBLY
KEEPER
WASHER
RIVET
P
F
F
K
K
YOU WILL NEED
2 x 3000mm 'U' channels with ends cut
2 x 1586mm door spacers
3 x padbolts
F
K
P
GALVO TIP
To hinge the door of your shed on
the opposite side, simply put the
top channel on the bottom and
the bottom channel on the top.
Put the padbolt on the door
before erecting the panels.
It will stop your garage door
swinging around!
Fix through the top and bottom of the channels into the door
jamb and spacer. The door jamb goes on inside of the channel.
SPACER
CHANNEL
3
CHANNELS
The higher side of the channel goes
to the inside of the shed. It is very
important to include the fixings on the
underside of all the channels as they
are structural (except roof channels).
OUTSIDE
INSIDE
F
CHANNELS WITH
CUTOUTS
The cutouts go to the inside
of the panel to allow easy
fitment of the end walls on
assembly (page 5).
TOP
BOTTOM
IMPORTANT ADDITIONAL INFORMATION
