Version 1, 10 November 2016, Page
2
of
4
INSTALLATION
IMPORTANT: Galvin Specialised products must be installed in accordance with these installation instructions and
in accordance with AS/NZS 3500, the PCA and your local regulatory requirements. Water and/or electrical supply
conditions must also comply to the applicable national and/or state standards. Failing to comply with these
provisions shall void the product warranty and may affect the performance of the product.
1. Disassembly
−
Disassemble components
−
Separate body washer, cartridge and locknut
2. Fit cartridge
−
Fit ceramic cartridge in to the wall body.
Fit
body washer
−
Do not over tighten and do not use spindle to
tighten.
3. Fit locknut
−
Fit locknut and tighten onto the cartridge,
ensuring fiber washer seals have a similar
tension to the conventional jumper valve
headpart.
4
.
Fit dress flange
−
Fit dress flange onto the locknut and tighten.
5
.
Fit dress flange with anti-rotation pin
−
If the anti-rotation option is required, fit dress
flange onto locknut and mark the wall. Remove
the flange and drill 3/16” hole 10mm deep.
−
Replace the flange and screw in the grub screw
to lock.
6
.
Fit lock sleeve
−
Fit lock sleeve and tighten to lock entire unit in
position.
