Version 3, 7 May 2020, Page
3
of
4
Version 1, 7 May 2020, 3 of 4
zVersion 1, 7 May 2020, 3 of 4
Version 1, 7 May 2020, 3 of 4
3.
Secure Mixer Body
To allow proper fitment of the wall flange,
allow a gap between 2mm & 7mm (as
shown) between the finished wall and the
rear of the main body.
Secure the mixer body using the mounting
points.
4. Fit Water Connections
Ensure water supply lines are flushed before
connecting.
Fit the water connections as shown.
Ensure thread tape/sealant is used.
Note: This wall shower is not fitted with a flow
restrictor. Never operate without a flow restrictor, as
outlet will deliver full mains pressure with
unrestricted flow.
5. Fit Handle & Flange
Re-fit handle & flange ensuring care is taken
to avoid scratching the mixer body.
6. Secure Handle & Fit Indicator Button
Using the supplied hex key, fit the grub screw
as shown and secure the handle.
Fit the indicator button as shown.
7. Test
Once the shower mixer has been fitted, turn on mains water and check for leaks and correct
operation.
Mounting point
Mixed water outlet
Cold water inlet
Hot water inlet