Version 1, 14
th
April 2020, Page
2
of
5
DIMENSIONS
– TM-BASXD
INSTALLATION
INSTALLATION COMPLIANCE: Galvin Engineering products must be installed in accordance with these
installation instructions and in accordance with AS/NZS 3500, the PCA and your local regulatory requirements.
Water and/or electrical supply conditions must also comply to the applicable national and/or state standards.
Failing to comply with these provisions shall void the product warranty and may affect the performance of the
product.
1. Fit Mounting Hardware and Hoses
Screw in and tighten flexi-hoses.
Fully screw in threaded rods as shown.
2. Fit Tap
Ensure the basin mounting hole for the tap is
as per the rough-in dimensions.
Ensure the O-ring is present underneath the
tap.
Carefully fit the flexible hoses and threaded
rods through the basin hole as shown.
O-Ring
Rough-In Dimensions
Ø35mm
