Version 1, 4 February 2020, Page
2
of
4
PRE-INSTALLATION -
MOUNTING DETAILS
If the mounting holes do not already exist, mark out and drill the holes in the wall/sheet, as shown in
rough-in dimensions.
Note: Before installation, all lines must be flushed. We recommend that a line strainer be installed
prior to drinking taps to eliminate any foreign material.
INSTALLATION
IMPORTANT: Galvin Specialised products must be installed in accordance with these installation instructions and in
accordance with AS/NZS 3500, the PCA and your local regulatory requirements. Water and/or electrical supply
conditions must also comply to the applicable national and/or state standards. Failing to comply with these provisions
shall void the product warranty and may affect the performance of the product.
1. Fit tap assembly
Fit wall plugs to wall as per rough-in
dimensions.
When applying thread tape or sealant to
the inlet, ensure the opening is not
obscured. Failure to do so may restrict or
block the flow restrictor, affecting the flow
of water.
Screw tap onto existing spud until the
flange is touching the wall.
Ensure the mouthguard is in the correct
position and the holes in the flange align
with the wall plugs.
2. Secure the body
Secure the body with supplied screws.
Rough-in Dimensions
