Page -10-
K9 Partner Power Door Opener System with PowerTouch Remote Control
Manual C840.N2
Installation: Electrical - Receiver Power & Ground
WARNING:
Disconnect the main battery power of the vehicle before starting installation of this system.
1) Install Power
Connect the Red wire to a co12v battery power source. Note: For best performance, run a
clean +12v directly from the battery or a fuse that is NOT supplying any power to motors, lights or
other high current devices, with the noted exception of the actuator supplied in this kit.
2) Install Ground
Connect the Black wire to chassis ground
A) Scrape all paint and grease away from the body frame.
A loose chassis ground connection WILL cause intermittent operation of receiver.
B) Clean the area using an alcohol based cleaner to remove paint chips and grease.
C) Crimp a #10, 3/16” ring terminal onto the black ground wire.
D) Insert the ring terminal and a #10, 3/16” star washer over a 10x3/4” hex head,
self-tapping ground screw.
E) Tighten ground screw securely into clean frame area.
WARNING!
Use ONLY a volt meter to check voltage
during installation and testing.
*Using a test light WILL damage the outputs!
(
-
)
Battery
(
+
)
#10 x 3/4” Screw
#10 3/16” Star Washer
#10 3/16” Ring Terminal
Vehicle Frame
Scrape paint and clean area before installing ground screw.
A loose chassis ground connection WILL cause intermittent operation!
Chassis Ground
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
Red
Violet
Pink
Green/Black
Yellow/Black
Brown
Blue
Black
(+) Input +12v Battery Power
(+) Output Channel 1 - Button ‘A’
(+) Output Channel 2 - Button ‘B’
(-) Output Channel 1 - Button ‘A’
(-) Output Channel 2 - Button ‘B’
(-) Output Channel 3 - Buttons ‘A’ & ‘B’
(-) Output Channel 4 - Back Button
(-) Input Ground - Connect to Chassis
Ground using External Tooth Washer
PowerTouch Remote Control System
Series 814 RF Receiver
This device complies with FCC rules part 15.
Operation is subject to the following 2 conditions:
1) This device may not cause harmful interference
2) This device must accept any interference received
including that causing undesired operation
36” Gray Antenna Wire
*Maximum output current 300mA.
Over current will damage outputs.
Auto Reset Circuit Breaker
10a Maximum
Diagram 10a
Bat
Aux
