ENG
ENG - 39
REMOVE THE HEPA FILTER
• When the fi lter indicator turns red fi lter need cleaning or replacing.
• Remove dust tank and pull the fi lter out in a horizontal direction. Replace, or rinse with warm
water. Allow to dry for 24 hours.
• Clean the HEPA filtr according to the cleaning instructions found in the manual.
• After this push the HEPA filter cleaning system back into position in the vacuum cleaner until it
snaps into place. Your vacuum cleaner is now ready for use again.
Note:
When the dust container is full, it is sensible to pull a plastic bag over it and to empty it into this
bag. This prevents the spilling of dust.
How to clean the hepa filter
It is very important to keep the filters clean to receive maximum performance from the vacuum.
Clean the filter regularly and replace the filters when necessary.
Cleaning is best done when emptying the dust container.
HEPA Dust Cup Filter will stop most of the tiniest dust particles and airborne allergens from re
-
-entering the air you breathe. In fact it stops 99.97% of all particles as small as 0.3 microns-ma
-
ny times smaller thana human hair! Because of this incredible filtration performance, the HEPA
Dust Cup Filter will quickly accumulate may fine dust particles inside the white filter folds that
are difficult to see but which will eventually block or reduce your suction power, if not cleaned
properly. We recommend washing it once a month or when suction appears to be reduced. To
wash your HEPA Dust Cup Filter, hold filter cartridge by frame flange and rinse under a tap until
all observable dirt has been removed. Some discoloration of the HEPA filter material may occur,
this is normal and will not affect the filter‘s performance. When finished, shake off excess water.
Do NOT wash in dishwasher.It is important that when you wash the HEPA dust cup filter, you
allow it to dry COMPLETELY before using again. We recommend 24 hours to air dry. DO NOT
DRY IN DRYER.
The HEPA filter operating lifetime corresponds to about 10 to 15 washing cycles. After that, the
filter looses its performance and it should be replaced.
Caution!
Only ever clean the filter with clean water and do not use soap or detergent. These would
destroy the filter.
Cleaning the exhaust air filter
The outlet air filter cleans the air a final time
before it leaves the vacuum cleaner. You can clean the outlet air filter as follows:
1. Switch off the vacuum cleaner and disconnect the plug from the mains. To do this always
pull on the plug and not on the cable.
2. Open the exhaust air grill (this is at the rear of the vacuum cleaner.)
3. The air filter is visible when the grill has been opened.
4. Rinse the filter under cold running water and allow dry.
ENG - 39
Содержание Verdun ASP 518WB
Страница 56: ......