ENG - 19
ENG
1) Unwind sufficient cord from the storage area to reach the power outlet.
Then place the power base on a dry, flat surface.
2) Open the lid and fill the kettle with cold water.
3) Make sure that the water level is between the minimum and maximum marks on the water
level scale. Do not switch on the kettle when empty.
4) Check and correct the filter’s position before boiling the water.
The automatic shutt off switch may not work properly without the filter.
5) Close the lid and place the kettle back on the base.
6) Plug to AC outlet with the voltage corresponded to the information on the product label.
7) Switch the kettle on by the main switch. The indicator light will go on showing that the water
is being boiled.
8) When the water has boiled, the kettle will switch off automatically.
9) Do not remove the kettle from the power base without first switching off.
10) Remember if you wish to re-boil, put the main switch of the kettle to the “ON” position.
11) The kettle may be switch off at any time by either pushing the main switch of the kettle
to the “OFF” position.
12) When water boils, the steam passes through the steam channel and then switches
off the kettle. To pour water, lift the kettle from the power base and pour.
13) When pouring out the water incline the kettle slightly and gradually.
Do not forget that hot water is inside.
14) An automatic safety boil-dry cut-out has been fitted for protection against overheating:
It will also operate if the kettle is switched on when containing insufficient water. Always
ensure the water inside the kettle covers the minimum mark on the water level indicator
gauge. If the cut-out has operated, switch the kettle off, disconnect from the power outlet
and allow the kettle to cool down for 5 to 10 minutes. Then refill with enough water and
switch on; the kettle will then boil and cut off as in normal operation.
CLEANING AND MAINTENANCE
1) Unplug the kettle and wait until it cools down completely before cleaning or storing.
2) To avoid the risk of electric shock, do not clean the exterior of the unit, its base or its power
cord with water, and do not immerse it in water. The exterior of the kettle may be cleaned
with a slightly damp non-abrasive lint-free cloth without additives.
3) The filter may be removed for cleaning purposes. To do this, place the filter vertically, pull
upwards and draw out. Wash the outside of the filter in the water flow.
4) Refit all parts when they are completely dry.
5) In the hard water area, it is important to do the decalcification regularly to keep the kettle in
good working condition, because too much scale inside may cause the kettle fail to work.
For the best performance of your kettle, decalcify the unit from time to time. The frequency
depends on the hardness of your tap water and how many times you have used the kettle.
Decalcification will clean the interior of the unit.
