Gallet ASP 410, Инструкция по эксплуатации

Страница: 33 / 52

You can connect the appliance directly to the hose handle or to the telescopic tube.
IV. USE OF VACUUM CLEANER
Remove all packing material, take out the vacuum cleaner and the accessories. Pull out
necessary length of power cord A10 and plug the power cord into a socket. Assemble the
vacuum cleaner accessories B (Fig. 2, 3, 4). If the cleaner is fitted with telescopic tube B3 ,
adjust its length to fit your figure (Fig. 3). Floor nozzle B1 is designed to be used to clean
carpets or smooth flooring (Fig. 5). If the floor nozzle is fitted with a brush, pull it out by
switching over a flap when vacuuming hard floorings. The parquet nozzle B7 is designed
mainly for vacuuming smooth floors (wood tiles, linoleum, floating floor etc.). The TURBO
brush B8 can be used to clean carpets with low hair and smooth floors (not suitable for
carpets with thicker hair). You can use crevice nozzle
B4
for vacuuming places that are
hard to access (Fig. 6). Upholstery nozzle B5 or brush B6 can be used to clean various
types of furniture (Fig. 7, 8). The vacuum cleaner can be switched on or off by pushing
button A4 marked with the symbol (Fig. 9). You can set the suction power by setting the
regulator
A6
. The minimum suction power is recommended for fine fabrics (e.g. curtains,
drapes). The maximum suction power is recommended for floor coverings (e.g. heavy-duty
carpets). After finishing work, switch off the vacuum cleaner and unplug it from the power
supply. By switching button A5 with symbol (Fig. 9) the power cord will be wound
automatically. The vacuum cleaner can be held and carried by handle
A9
.
Full dust filter signaling
If the coloured field is displayed permanently on the indicator A7 while the floor nozzle is
lifted above the cleaned surface at the maximum suction power , the dust filter A15 must
be replaced. Disregard changes on the indicator during vacuuming.
Dust filter replacement
Lift off vacuum cleaner lid A3 by pushing lock A2 to the locked position (Fig. 11). Then
follow the instructions for the respective type of a dust filter.
Note
– The safety feature will not allow the cleaner lid to be closed, if you forget to insert the
dust filter (paper, synthetic or textile; with the UNIBAG bag, the lid cannot be closed only
when the bag is taken out along with the adapter).
Paper / synthetic filter: pull out the dust filter lock A15 from the guide ribs of the holder
A14 (Fig. 12) and dispose it with common municipal waste. Slide
the front part of the dust filter (in the direction of the arrow) to
holder in the suction space of the vacuum cleaner and push it to
the maximum position.
UniBag: hold adapter C and remove it from the guide ribs of holder A14 by pulling it
(Fig. 12). By lifting off lock stop C1 , dust filter A15 will be released from the holder/
adapter (Fig. 16). Dispose of the dust filter with common municipal waste. Slide
the projections on the front of a new dust filter into the holes in adapter C and
secure the front by slight pushing. You will hear a clicking sound. Check proper
fastening of the front by slight pulling of the dust filter. Slide the adapter with a filter
to the holder in the suction space and push it to the maximum position. Close the
vacuum cleaner lid by snapping it shut. You will hear a clicking sound.
EN
33 / 44