SmartScale 600
User Manual
Page 15
Changing drafting numbers
1.
Press the
button repeatedly to select the drafting
category (
H Gates
,
C Gates
or
L Gates
) you want to change.
2.
Using the keypad, press the required digit (a number between 1
and 9) to set the route the animal in this drafting category must
follow.
•
Refer to the drafter manufacturer's specification to determine
the drafting number corresponding to the drafting direction.
•
If you enter 0, the gate setting will be cleared. This means no
gate changes on the drafter will occur when an animal in this
drafting category is weighed.
3.
Press
to save the changes and return to the setup menu.
Configuring the connection to the drafter
To configure the connection between the Scale and the automatic
Drafter, follow these steps:
1.
Set the mode select switch to
S
.
2.
On the numeric key pad, press
5
to select the Communications
menu.
3.
If necessary press the
button to select the port to which
the DRAFTer is connected.
4.
Press the
button repeatedly until
DRAFTER
displays.
5.
Press the
button.
Resetting the drafter
Some drafters require that all gates are reset after the weighed animal
has passed through and before the next animal is weighed. If you need
to reset the DRAFTer between measurements, carry out steps 1
through 5 but select
DRAFTER SPECIAL
at step 4.
