GALKIN GAP-X5, Руководство по эксплуатации и список запасных частей

Страница: 8 / 63

B. Motor Rotation
The machine hand wheel must turn clockwise when viewed from the hand wheel end. The
oil pump will not function when the machine operates in reverse rotation. To check
rotation, turn on the motor and use the foot pedal to turn over the machine slowly, while
checking direction. Do not run the machine for an extended period. If the hand wheel turns
in the wrong direction, stop immediately. Turn off the motor and unplug power. Reverse
motor direction by rewiring connections or reprogramming as appropriate. For single phase
motors, a diagram may be found for reverse wiring, either on the specification plate or
inside the wire connection access opening. For 3-phase motors, exchange connections of
any two of the three “hot legs” Servomotors are reversed by programming. Check motor
manual for method of programming rotation.
C. Motor Speed
Maximum recommended sewing speed is 4200 stitches per minute. Pulley combination and
or motor settings have been chosen to reflect this recommendation. The sewing machine is
capable to speeds up to, 5800 stitches per minute. At such speeds; however, wear life of
parts become a problem. Of particular concern would be wear to top feed parts; especially
the top feed belt, clutches and eccentric tie rod ends.
D. Threading
Thread the sewing machine as shown on the threading diagram, Figure 04.
E.
Flange Guide Adjustment
Adjust the flange guide to control the flange material. Material should be able to move
freely from under the sewing machine stand, around the curved flange guard, and through
The flange guide to feed straight into the machine. Referring to Figure 05, adjust the flange
guide to control the flange. Set the panel guide to guide the pad into the sewing machine.
F.
Optional Flange Handling Equipment
1.) Flange Rack
An optional flange rack is available for the Galkin 3350-X5 Flanger. If this option
has been purchased, it is to be mounted to the vertical supports of the machine stand. Note
that, when held between the reel flanges, flange material should guide straight through the
flange guide at the front of the table.
Flange rolls can be loaded to the rack by lifting one end of the shaft and sliding the
roll into position making sure it does not restrict the flange material from
feeding to the flange guide.
From the library of: Diamond
Needle
Corp