9
* Place the paper with its printed side down in case of fold-out.
(5) Place the paper on the feed table so that it touches the paper lightly, and then tighten the
paper setscrew.
(6) Lower the paper feed table lever and set the paper.
* If the paper does not come in contact with the paper feed roller, it may be fed improperly. In
such case, the leading edge of the paper may touch the guide plate in the front and prevent the
paper from being fed. In this case, reset it by sliding it a little backward.
* If the paper has curled or wrinkled part, it may cause trouble. Correct it before use.
* In case of printed paper, use it only after the ink is dry, otherwise the paper feed rubber roller,
paper separator, fold roller, and other parts of the unit will be stained with ink, which may cause
trouble.
* Do not use ruled paper as it may cause paper folding to deteriorate.
(3) Setting Paper Exit Roller
Set the paper exit roller at the indication for the
size of paper stock table used. If the roller is set at
a wrong position, it may cause trouble such as a
coiling of paper around the roller.
* The folded paper length may be altered
depending on fold type and paper curl may be
caused by changes of temperature and humidity.
Therefore, whenever paper jam occurs at the
stage of ejection, reset to adjust the paper eject
roller to the best position.
(4) Setting Paper Stacking Table Pull out the paper
stacking table and set it so that the ejected sheets
flow out smoothly.
2. Operation Procedure
(1) Switch the power on.
Insert the power plug into the outlet.
Switch the power on.
* Be sure to remove the power plug from the outlet after use.
(2) Setting Paper Fold Position
Pull the half-nut lever in the direction of the arrow to move the stopper plate to the desired
position on Table 1 and 2, matching the stopper plate mark(
) with the position, and leave
the half-nut lever there. The stopper plate automatically locks at the position where the half-nut
lever remains.
* In case of single fold only, all sizes paper should be set at the position of “ALL SIZES”. Should
wrinkles or irregular folding occur in single fold, move the stopper plate until halting by the
Paper discharge roller
